jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
Tekstowy podgląd strony 15 (kliknij aby zobaczyć)
Mechanical instructions
EM5E-DVD
4.
EN 15
1
CL 26532086_025.eps 050702
CL 16532021_012.eps 300301
Figure 4-4 DVD-tray release catch.
Figure 4-6 Cable routing 1
1
CL 16532021_013.eps 300301
CL 26532086_026.eps 050702
Figure 4-5 DVD fixation screws. 4.1.4 DVD Eject Switch � To access the DVD eject switch, unscrew the two fixation screws and pull the switch out of the cabinet. Remove the switch cable if necessary. The switch panel can now be removed. To reassemble the switch, make sure that the cable is fixed before mounting.
Figure 4-7 Cable routing 2.
�
4.1.5
Attention Point � The routing of some cables is very critical. So therefore, take care that the cables are routed as shown in pictures hereunder. Not routing the cables in this way can cause problems like picture disturbance and EMC problems. � Routing of the cable between LSP connector 1936 and DVD Interface connector 0240 (blue 11-pins cable): guide the cable as close as possible to the SSB shielding en than between the cable relief of the scavem-assy (Auto-scavem board itself is not present in EM5E-DVD), and from there to the DVD-interface. (See figure �Cable routing 1�) � Routing of speaker cable and top control cable: make sure this cables are routed between the DVD lock plate and the DVD board. Also make sure to guide them underneath the two flat foil cables. (See Figure �Cable routing 2.�)
