|
|
|
Kto jest w sklepie?
Sklep przegląda 5068 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dobrej jakości skan - wkońcu mogłem poznać wszystkie funkcje tego odtwarzacza - polecam .
;
Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Getting Started
English
Step 1: Inserting batteries into the Remote Control
3 1 2
� Usually these channels are between the lowest and highest channels and may be called FRONT, A/V IN, or VIDEO. See your TV manual for more details. � Or, you may go to channel 1 on your TV, then press the Channel down button repeatedly until you see the Video In channel. � Or, the TV Remote Control may have a button or switch that chooses different video modes. � Or, set the TV to channel 3 or 4 if you are using an RF modulator. Selecting the colour system that corresponds to your TV This DVD Player is compatible with both NTSC and PAL. In order for a DVD disc to play on this Player, the colour system of the Disc, the TV and the DVD Player should match.
1 2 3
Open the battery compartment. Insert two AAA batteries following the indications (+/-) inside the compartment. Close the cover. Using the Remote Control to operate the Player
1 2
Aim the Remote Control directly at the remote sensor (IR) on the front panel. Do not put any objects between the Remote Control and the DVD Player while operating the DVD Player. CAUTION! � Remove batteries if they are exhausted or if the Remote Control is not being used for a long time. � Do not use old and new or different types of batteries in combination. � Batteries contain chemical substances, so they should be disposed of properly.
1 2 3
Press SYSTEM in full stop mode. Press 1 2 to select �Preference Page�. Use 1 2 3 4 on the remote to navigate in the menu. Move to �TV Type� and press 2. � PAL: Select this if the connected TV is PAL system. It will change the video signal of a NTSC disc and output in PAL format. � Auto: Select this if the connected TV is compatible with both NTSC and PAL (multisystem). The output format will be in accordance with the video signal of the disc. � NTSC: Select this if the connected TV is NTSC system. It will change the video signal of a PAL disc and output in NTSC format.
Step 2: Setting up the TV
IMPORTANT! Make sure you have completed all the necessary connections. (See �Connecting TV�).
4
Select an item and press OK. Notes: � This option is available only when the "HDMI" is set to "OFF". � Before changing the current TV Type setting, ensure that your TV supports the selected TV Type.
1 2
Switch the DVD system on and then select DISC source. (See �Switching the system on/off�). Turn on the TV and set to the correct video-in channel.You should see the blue Philips DVD background screen on the TV.
18
|
|
|
> |
|
