Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 15 (kliknij aby zobaczyć)
Radio Reception
1
STANDBY-ON
MICR O SYSTE M MCM148
Press ALBUM/PRESET +/- to select the preset number where programming should start. Note: � If no preset number is selected, default is preset (1) and all your presets will be overridden.
iR
MP3-CD/CD-R/CD-RW COMPATIBLE
2
MODE PROG
SOURC E
VOL
ALBUM/ PRESET
TUNING
Press PROG. for more than 2 seconds to activate programming. � AUTO is displayed and available stations are programmed in order of waveband reception strength. The first preset automatically stored will then be played. Manual programming
VOL
DBB
Tuning to radio stations 1
Press SOURCE on the set repeatedly or press TUN on the remote control repeatedly until the desired waveband (FM or MW) is displayed. Press down on TUNING 4 ¢ (à / á on the remote control) and release the button. � The radio automatically tunes to a station with sufficient reception. Display indication during automatic tuning: SEARCH. Repeat step 2 if necessary until you find the desired station.
1 2 3 4 5
Tune to your desired station (see Tuning to radio stations). Press PROG. to activate programming. � PROG flashes in the display. Press ALBUM/PRESET +/- to allocate a number from 1 to 40 to this station. Press PROG again to confirm the setting. � PROG disappears, the preset number and the frequency of the preset station are shown. Repeat the above four steps to store other stations.
2
3
� To tune to a weak station, press TUNING 4 ¢ (à / á on the remote control) briefly and repeatedly until you have found optimal reception.
� You can override a preset station by storing another frequency in its place.
Tuning to preset radio stations
� Press ALBUM/PRESET +/- until the desired preset station is displayed.
Programming radio stations
You can store up to a total of 40 radio stations in the memory. Automatic programming Automatic programming will start with a chosen preset number. From this preset number upwards, former programmed radio stations will be overridden. The system will only programme stations which are not in the memory already.
