Important notes for users in the U.K.
Mains plug This apparatus is �tted with an approved 13Amp plug.To change a fuse in this type of plug, proceed as follows: Remove fuse cover and fuse. Fix the new fuse which should be a BS1362 5Amp, A.S.T.A. or BSI approved type. Re�t the fuse cover. If the �tted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug should be �tted in its place. If the mains plug contains a fuse, it should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. Note:The severed plug must be disposed, so as to avoid a possible shock hazard due to it being inserted into another 13-Amp socket. How to connect a plug The wires in the mains lead are coloured using the following codes: blue = neutral (N), brown = live (L). As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: � Connect the blue wire to the terminal marked N or coloured black. � Connect the brown wire to the terminal marked L or coloured red. � Do not connect either wire to the earth terminal in the plug, marked E (or e) or coloured green (or green and yellow). Before replacing the plug cover, make sure that the cord grip is clamped over the sheath of the lead and not simply over the two wires. Copyright in the U.K. Recording and playback of any materials may require consent. See Copyright Act 1956 and The Performerb�s Protection Acts 1958 to 1972.
